Red Pine Tar, 2.7 L
Red Pine Tar on Chalmers University Student Union Country House, Sweden.
Red Pine Tar on a log house in Sweden.
Red Pine Tar for Swedish Villa in Paris.
Red Pine Tar on vertical board and baton siding.
Red Pine Tar can be applied in direct sunshine.
Red Pine Tar
Red Pine Tar

Red Pine Tar

Item # : 60510401
Regular price $46.20


Red Pine Tar is made from Genuine Dark Pine Tar with natural red oxide pigment added. The pigment gives a classic, matte red finish that is so traditional in Sweden for hundreds of years, and it is also finding popularity on modern structures, bridges, and any outdoor surface where a strong red colour is desired. Additionally, it protects the wood against the elements, including UV rays on surfaces strongly affected by the sun.

Pine Tar has a long documented history of being used to penetrate and protect wooden surfaces outdoors, while still allowing it to breathe. Mix with Purified Linseed Oil to create a natural, red wood stain, giving better penetration and a surface that finishes matte and less sticky.


Before diving in, use the Pine Tar Test Kit to help with learning the nuances of the material for staining and protecting surfaces and to ensure you achieve the desired result. Test the colour on your particular surface, and test application methods and strategies for your particular project.


Apply Red Pine Tar to bare wood or to wood that was formerly treated with Pine Tar, natural oil, such as Purified Linseed Oil, or distemper paints such as Falun Paint.

Clean the surface with Linseed Soap and water to remove dust and dirt from the wood with a brush. Rinse well and allow to dry.

Pine Tar comes concentrated, and there are many old recipes for dilution, but we like to mix 50/50 with Purified Linseed Oil and apply the mixture warm (approx. 60ºC) and to a warm surface in order to avoid the need for solvents. This helps to promote penetration into the wood for a long-lasting result. Adjust the ratio according to your project. See the Auson Technical Data Sheet below for more detail.

The approximate spread rate of this pine tar mixture is 60-100 sqft per litre, depending on the mixing ratio, density, smoothness, and overall condition of the substrate. It is also important to consider the environmental conditions. See the Auson Technical Data Sheet below for more detail.

Minimum operating temperature: 10 - 15ºC on the surface and in the air. Beware of invisible condensation on surfaces below 15ºC.

Always stir well before painting, since the pigment will settle near the bottom of the can during storage. Stir regularly while painting, too. This will help to ensure the pigment is evenly distributed in the can and help to ensure an even colour on the facade.

Drying can take from several days to several weeks depending on the weather and other environmental conditions as well as on the condition of the surface and its porosity.


Red Pine Tar is a product from nature, where the appearance may vary slightly from batch to batch. For larger quantities, it can be a good idea to mix several cans together for better uniformity.

Raw Linseed Oil is a deep penetrating oil that is slow to dry. It must be well absorbed by the timber and is well suited to most projects, including wooden facades and roofs.

Boiled Linseed Oil is a drying oil that can become hard and form a film on the surface after several coats and is well suited to projects where a faster drying time and harder finish is desired, such as walked-on surfaces.


TDS Red Pine Tar
SDS Red Pine Tar

Pine Tar Painting Guide